Endless hot water on demand from a compact continuous-flow system, supplied, installed and certified by licensed plumbers and gasfitters under one roof.
A gas continuous-flow system heats water instantly as it passes through the unit, so you get endless hot water on demand without storing it in a cylinder. It’s compact, wall-mounted and only heats the water you actually use, ideal for busy Auckland households that never want to run out.
Indicative fixed-price examples across our hot water systems. Your final quote depends on your existing setup and access.
Endless hot water, anywhere.
Perfect for homes without a natural gas connection. A continuous-flow system running on LPG bottles gives you endless hot water on demand, wherever you are in Auckland.
From $2,950 + GST installed
Key Benefits
Endless hot water, lower running costs.
The efficient gas option for homes connected to natural gas. A continuous-flow system delivers endless hot water on demand at a lower running cost than bottled LPG.
From $2,950 + GST installed
Key Benefits
Reliable stored gas hot water.
A gas-heated storage cylinder like the Rheem Stellar is a dependable choice where continuous flow isn’t suitable, keeping a ready tank of hot water heated by gas.
From $3,950 + GST installed
Key Benefits
Never run out, even with back-to-back showers.
Strong supply for multiple outlets at once.
Compact wall-mounted unit frees up room.
Efficient, no standby tank heat losses.
Consistent hot water at the temperature you set.
Quality Rinnai & Rheem continuous-flow systems.
“Prompt and efficient service at a reasonable price. The plumbers who attended were polite and friendly and cleaned up well afterwards. Recommended.”
Larry Robbins
“Replaced our old low pressure cylinder with high pressure gas. Fast, efficient and very reasonably priced.”
Aaron Dolbel
“Prompt, highly efficient and a pleasure to deal with.
5 star service.”
Ben Dailey
Good to know
Final price depends on your existing setup and access. Most jobs quoted from photos, no site visit needed.
You’re sick of continual gas price hikes and want the lowest running costs over time, in which case our Air to Water Heat Pump may suit you better.
Installation starts from $1,990 + GST for a standard replacement. The final price depends on the unit you choose, your existing gas and plumbing setup, and access at your property. Most jobs can be quoted from a few photos, with a fixed price confirmed before we start, so there are no surprises.
Yes. A gas infinity (continuous flow) system runs on gas, so you’ll need either a natural gas connection or LPG bottles. If your home isn’t on natural gas, LPG is a common and reliable alternative across Auckland. We can check whether your existing gas supply is suitable and advise on the best setup for your home.
Because it heats water on demand, a continuous flow system never runs out. A unit like the Rinnai A26 Infinity delivers up to 26 litres per minute, which comfortably covers the hot water needs of a typical household.
Yes, within the system’s flow rate. Up to 26 litres per minute is generally enough for two showers at the same time in most homes. If you have very high simultaneous demand, such as multiple showers plus other outlets running together, we can advise on a higher-capacity unit or a second system.
Most straightforward replacements are completed within a single day, and we can usually have your hot water back on the same day to keep disruption to a minimum.
Yes. In most cases we can provide a fixed-price quote from a few photos of your existing cylinder and surrounding area. If we need anything else, we’ll let you know.
Central, West, North Shore, East & South. Same-day emergency callouts available.
Send a few photos of your current system and we’ll usually quote the same day.
